Tactical Scorpion Gear has taken the armor plate carrier to the next level. Convertible dual pocket design which can accommodate either a 8"x 10" or 10" x 12" single plate or a 10" x 12" rigid Level IIIA with a 8" x 10" Level III AR500 plate as back-up for cardiovascular protection.
Our lightweight quick donning carrier vest complete with 10" x 12" or 8" x 10" Ar500 Level III plate.
Weighing in at only 1.5 pounds empty is our most lightweight carrier
Tactical Scorpion Gear Lightweight carrier vest . This vest provides pockets for the front and rear armor up to 10" x 12". Made of 600D nylon. This vest comes complete with armor . This is a Tactical Scorpion Gear exclusive design.
Made for quick and easy placement for in case of emergency.
Tactical Scorpion Gear AR500 steel plate armor . (Made in the USA)
We utilize a CNC laser cutting table for the cutting of all our AR500 products. If the seller of armor plate does not mention how its cut, then you can guarantee its not by laser There is no equal method
Plasma cutting cuts slowly, this puts a lot of heat into the steel. ( Submerged plasma cutting machine is no better) This excess heat can result in excessive chipping and damage near the cut edge during use and easily shattering when shot. Plasma cutting generates large amounts of heat that is deposited into the target, softening its edges. The heat-affected zone (HAZ) generated by plasma cutting is the largest out of the most commonly used methods for cutting abrasion resistant steel. Most AR500 is cut with plasma cutters as they are cheap and relatively small compared to other methods.
Our Curved plate is bent on a custom laser cut die set with single radius bend, not bent multiple times on a press brake.